Easy To Install Ferrules

Easy To Install Ferrules


Easy Install Black Iron Ferrules .370" - 1 Dozen
$2.49
In Stock
Easy Install Black Wood Ferrules .335" - 1 Dozen
$2.49
In Stock

Easy To Install Ferrules

The Easy to Install Ferrules feature a larger inside diameter to easily slide over most graphite and steel shafts without the need for a ferrule installer tool while not being too large to cause the ferrule to tilt off center when installed on the shaft. It is required that the Easy to Install Ferrules are epoxied into place when assembling the golf club. Available for woods and irons in both black and black with a chrome trim ring.

Easy Install Iron Ferrule Specifications

Easy To Install Ferrules is rated 5.0 out of 5 by 2.
Rated 5 out of 5 by from Live up to the name I had just used some regular ferrules 61PI I think and they were super difficult to get on. Seemed like they were undersized. I even had trouble putting them on steel shafts. So I tried the easy on ferrules. No problems getting on the shafts. Just have to be careful wiping off excess epoxy so you don't dislodge them.
Date published: 2015-06-18
Rated 5 out of 5 by from Only Ferrule I use anymore There is no visible gap on these. I was worried that there would be a thin opening between the top of the ferrule and the shaft. Nope! Nothing! These are so easy to put on. I ordered a set and then after the first use I ordered 5 more in case they stopped selling them. Great product!
Date published: 2015-09-18
  • 2016-09-26T07:48CST
  • bvseo_cps, prod_bvrr, vn_cps_3.4.0
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_2
  • loc_en_US, sid_84PI, PRD, sort_relevancy
  • clientName_golfworks

Do you carry oversize ferrules. Larger than .370. I have a Taylormade bubble shaft for an iron and .370 won't fit. Need a little larger.

Asked by: Bob
We do not stock a .400" ID ferrule to fit the Taylor Made Bubble shaft these days. However I do have some in our school. If you are placing an order mention that Jim has some .400" ID ferrules for the Taylor Made Bubble shaft in the school and we can put some in an order for you.
Answered by: JimY
Date published: 2016-04-13

I need ferrules for a ping driver g 15 please help

Asked by: Mike p
The Ping G15 used a .350" tip diameter shaft. If you are installing a .350" tip diameter you will need the BB9048 and specify the .350" size. If you are installing a .335" shaft into the Ping G15 you will again need the BB9048 but specify the .335" size. http://www.golfworks.com/product.asp?pn=BB9048
Answered by: JimY
Date published: 2015-08-27
  • 2016-09-26T07:55CST
  • bvseo_cps, prod_bvqa, vn_cps_3.4.0
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_2
  • loc_en_US, sid_84PI, PRD, sort_recentAnswersFirst
  • clientName_golfworks