Economy Ferrule Turning Arm

Economy Ferrule Turning Arm


Economy Ferrule Turning Arm -
$19.99
In Stock

Economy Ferrule Turning Arm

Designed for use alongside The GolfWorks 1 x 30 Belt Sander (IVS3C). Mounts easily next to sander, and the height is a perfect match for the belt. Safely and controllably turn ferrules.

Not Found

Once you mount the Arm to your workbench, it appears that to align the Sander in order use the Arm, you need to place the front legs of the Sander on top of the base of the Arm, which results in the Sander Table not being level. Is that correct?

Asked by: Paul
This stand sets to the side of the belt sander. I prefer to set the Arm to the left side of the belt sander with the flat piece closest to the machine and then end with the two prongs facing up away from the machine. In our on line catalog there is a picture on page 167 but they set the arm to the right hand side of the machine, which I might do if I was left handed. http://mydigimag.rrd.com/publication/?i=294516#{%22issue_id%22:294516,%22page%22:0}
Answered by: JimY
Date published: 2016-09-12

Can you change out the sanding belt with the polishing belt

Asked by: Red1
On the bottom of the yellow guard there is a tab that you push down and out and it will open. To the right of the post there is a knob. Loosen the knob and then push down on the top of the yellow guard to loosen the belt and remove the belt. To install the new belt push down on the yellow guard to compress the spring and install the new belt. Close the yellow guard box. You can rotate the yellow guard box right of left to align the belt. Do that and then re tighten the knob and you are ready to go.
Answered by: JimY
Date published: 2016-03-29

I have the belt sander machine as well. I am not sure where this product attaches. What do you mean by the 2 screws? Is there an instruction? Or pictures?

Asked by: CKim
This product attaches to your work bench. The 2 screw would mount this to your work bench. I have used this by clamping to the bench using C clamps. If you have our 2015 catalog on page 167 there is a picture of the setup with the belt sander. The stand could be set up on either side of the machine depending on if you are right or left handed. You could also see the picture in the online version of the catalog on page 167. http://mydigimag.rrd.com/publication/?i=252739
Answered by: JimY
Date published: 2016-02-01

I own the Golfworks 1x30 belt sander. Just ordered this item and I am curious if it comes with directions on how to mount it to the sander. Looking at the picture, it is not obvious to me.

Asked by: Neal
The ferrule turning arm mounts to the bench top with two small screws. It does not attach to the 1x30 belt sander.
Answered by: Admin
Date published: 2015-02-05
  • 2016-12-10T08:08CST
  • bvseo_cps, prod_bvqa, vn_cps_3.4.0
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_4
  • loc_en_US, sid_EFTA, PRD, sort_recentAnswersFirst
  • clientName_golfworks