Callaway Opti-Fit Shaft Adaptor Sleeve
This authentic Callaway factory Razr Fit - OptiFit Hosel adjusts the face angle in Open, Square or Closed positions at address to improve accuracy and trajectory. Available in RH & LH in both .335" and .350".
- Opti-Fit adaptor fits all Callaway adjustable drivers, Razr-Fit, Razr-Fit Xtreme and X-Hot.
(3 customer reviews
Overall Rating: Write an online review
and share your thoughts with other customersSort Reviews: Newest
| Highest Rating
| Lowest Rating
- Monday, April 22, 2013
Reviewed By: Anon
The review below sounds like an installation, not QC, issue. I've had no problems with these adapters. The inside of the ferrule should be abraded and glued so it will no slide up the shaft. The ferrule itself is collared so protects the shaft from snapping at the top of the adapter.
- Thursday, October 04, 2012
Reviewed By: Badger
Epoxied in place using Golfworks epoxy. Epoxy set up well. Installed a head and in 9 holes the head was moving. Removed head and checked adapter and found the tip portion where it screws into the head moved. I bought two and have installed the second. More later.
- Sunday, January 06, 2013
Reviewed By: Curtis
Had this put on my Graphite Design shaft and it worked well for 5 or 6 rounds...but then I noticed that it is separating at the ferrule. There is about a 3/16th inch gap now, and growing. It also rattles now upon impact :( I'm afraid the driver head will come flying off if I continue to use it.Read More Reviews