Hold heads for reaming or boring with the non-marring aluminum clamping jaws. 3/4" jaws for short or long hosels. Club rests against the protective nylon back plate. Fully adjustable to fit any hosel size. 3/4" jaws for short or long hosels. Club rests against the protective nylon back plate. Fully adjustable to fit any hosel size. Bolts directly to your drill press.
Reaming and Boring Vise is rated
5.0 out of
Rated 5 out of
Amazingly SimpleBought this because I had to re-bore an entire set of irons from .355 to .370 for a re-shaft job. This is a simple tool that does one job, and does it very well! The picture in the printed catalog doesn't include the handle on the side, and it wouldn't be nearly as handy without it. It allows you to hang on with one hand, and work the drill press with the other, so it makes it more feasible to not bolt/clamp it down. Bored out the 7 heads in about 15 minutes, and was very pleased with how this performed. Simple and accurate, and made the job easy, just like the other Golfworks tools I've bought over the years.
Date published: 2013-10-21
bvseo_cps, prod_bvrr, vn_cps_3.3.0
co_hasreviews, tv_0, tr_1
loc_en_US, sid_RBV, PRD, sort_relevancy
What is the delivery including customs etc for a reaming vise to United Kingdom
Asked by: clubmaker
Our shipping cost is $55.44. That does not include duties and taxes which are taken care of on your end.
Answered by: JimY
Date published: 2015-08-05
Can this be mounted on a drill press
Asked by: Charlie Brown
Yes, the Reaming and Boring Vise is designed to be mounted onto a drill press table.