TaylorMade RBZ Special Buy 2 Get 3

TaylorMade RBZ Special Buy 2 Get 3

TaylorMade RBZ .335" (RH) Buy 2 Get 3
In Stock

TaylorMade RBZ Special Buy 2 Get 3

Factory adjustable adaptor replacement sleeves for the TaylorMade™ RBZ drivers. Other than replacing a defective Adaptor, the Adaptor Sleeves can also be used to create multiple shaft options for the TaylorMade RBZ driver for less than the cost of simply reshafting your current shaft sleeve.

AccessDeniedAccess Denied655DFF281B6FE19AWATUGWbkKfZmvOfrb4DaVoC+L5LbGjJJt+o3HgDoqnJ8NYxt8yoRxS9x+UGej2AIEUwRi7NFaVg=

How do you install the adapter.  Does it make a difference where you put the writing on the ferrell when you install it. 

Asked by: Brian123
You do need to align the shaft for the correct setting that you will be using when the adaptor is installed into the clubhead but other then that where you align the graphics on the shaft is up to you. If you had the shaft Pured it could cause you to install the shaft with the graphics in a specific position. Shafts do not come Pured from the shaft manufacture. http://www.golfworks.com/article.asp?ai=495&eid=SSTPURE
Answered by: JimY
Date published: 2015-05-04

Do I need to purchase one of these if I'm replacing the shaft in my current driver? I'm considering purchasing an Aldila NV55 (R) flex shaft.

Asked by: John Wyant
If you have the Rocketbalz driver you would either need to purchase this adaptor or remove the existing shaft from it's adaptor and reuse that adaptor. For the Aldila NV55 shaft which is a .335" tip diameter you would need to order the TM0017 and request or check the .335" size.
Answered by: JimY
Date published: 2015-01-28
  • 2016-08-29T08:18CST
  • bvseo_cps, prod_bvqa, vn_cps_3.3.0
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_2
  • loc_en_US, sid_TM0017S, PRD, sort_recentAnswersFirst
  • clientName_golfworks