Hosel Honing Wire Brush

Hosel Honing Wire Brush


Bit for Irons
$4.99
In Stock
Bit for Woods
$4.99
In Stock

Hosel Honing Wire Brush

The easiest way to clean out hosels. For use with all drills. Cleans out hosels quickly and easily and prepares them for re-assembly. We recommend that the hosel be cleaned out using a cotton swab dampened with solvent after use.

Not Found.

Which brush is wider the iron or woods one.

Asked by: Jimbo
The iron brush wold be the wider one. Designed for .355-.370 hosel bores, where the wood brush is designed to work in .335-.350 hosel bores.
Answered by: GW2002
Date published: 2017-03-31

will the wood bit work for irons since it's smaller in diameter and still fit in? i currently see the iron bit as backordered.

Asked by: andy15
Yes this wood bit will still work just fine in an iron.
Answered by: JimY
Date published: 2017-02-09

What is the difference in the brush for irons and the brush for woods? What are the respective diameters?

Asked by: Mike
The brush for the Woods is sized for a .335" hosel bore and the irons for a .355" or .370" hosel bore iron.
Answered by: JimY
Date published: 2017-01-22

Will this product clean out pieces of old shat that broke off.

Asked by: David
No these brushes will not clean out pieces of broken steel shafts. They can help clean out pieces of broken graphite shafts. If you have a broken steel shaft you will need to use a Broken Steel Shaft Extractor first to remove the shaft then use the brush to clean out any remaining epoxy. http://www.golfworks.com/true-temper-belly-long-putter-shafts/p/SKP/ http://www.golfworks.com/fast-extract-universal-handle/p/GW1108/
Answered by: JimY
Date published: 2016-08-01

Are the bristles stainless steel, carbon steel, etc?

Asked by: Insidetheleather
Stainless Steel.
Answered by: JimY
Date published: 2017-01-13

Can you use this product to clean out the epoxy inside a taper tip steel shaft?

Asked by: mjr
No these will not fit inside the tip of a steel shaft. I personally use a drill bit to clean out epoxy from inside the tip of a steel shaft.
Answered by: JimY
Date published: 2017-01-13

When will the bit for Irons be shipped out if backordered?

Asked by: Ricky
We have them in stock here in the US so I would think Canada should have them shortly. To be sure it would be best to contact GolfWorks Canada and they will be able to help you.
Answered by: JimY
Date published: 2017-01-13

Can the .370 iron brush be used on .355 taper iron hosels?

Asked by: NJDon
Yes it will work.
Answered by: JimY
Date published: 2016-01-19
  • y_2017, m_5, d_25, h_11CST
  • bvseo_bulk, prod_bvqa, vn_bulk_1.0.0-hotfix-1
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_11
  • loc_en_US, sid_GW1060, prod, sort_[SortEntry(order=LAST_APPROVED_ANSWER_SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_golfworks