Powdered Lead - 1lb

Powdered Lead - 1lb


1lb. Powdered Lead
$9.99
In Stock

Powdered Lead - 1lb

Many manufacturers and custom clubmakers use Powdered Lead in a cavity under the soleplate to final balance and weight clubs. Usually this cavity is accessible thgrough a small hole sealed with a headless hex type set screw To use Powdered Lead, remove the set screw and pour the lead into the cavity. Verify swingweight, then epoxy the set screw back in place. 1-lb. container.
Not Found.

I would like to know particle size mash or micro meter.

Asked by: SangJae
We do not have a powder particle size for the Lead Powder. It is a fairly fine powder. The only information we have would be on the SDS or Safety Data sheet. You can send an email to customer service at golfworks@golfworks.com and they can email you a copy of the SDS sheet.
Answered by: JimY
Date published: 2017-01-27

I want to add weight to a hybrid head what is the best way

Asked by: john r
If you are increasing the swingweight lead or tungsten powder down inside the shaft is one way this is often done. You would need a run a cork down inside the shaft to hold the weight in place. If it is a graphite shaft I would use the Cork for woods and you still may have to cut it down to a smaller size to get down inside the shaft. You will also need a ram rod to get the cork down inside the shaft. If you are adding weight inside the clubhead itself using lead or tungsten powder along with clubhead tac is another way this is done. I have added weight to the clubhead by using a combination of clubhead tac and tungsten powder. The Clubhead Tac adds some weight itself and holds the tungsten powder in place. The other way to increase the swingweight is to use lead tape on the clubhead. http://www.golfworks.com/search.asp?ss=clht http://www.golfworks.com/swingweight-shaft-corks/p/CI/ http://www.golfworks.com/the-golfworks-44-1-2-ram-rod/p/RR/ http://www.golfworks.com/search.asp?ss=LT100
Answered by: JimY
Date published: 2016-10-25

Hi I want to add up to 8 grams to each club to increase the swing weight. The top of the shafts have extenders so I can not insert a cork after filling with the powder. The extenders have a narrow hole. Do you have any suggestions?

Asked by: Jeff
If you want to keep the lead powder in tip =use steel wool and use a ram rod to tamp it in.
Answered by: tom
Date published: 2017-02-01

is it pure ?

Asked by: lencgold
I tried to send an email with the SDS sheet but it came back. It does list this as 99% pure.
Answered by: JimY
Date published: 2016-04-19

Pb powder particle size spectrum?

Asked by: landag
We do not have a powder particle size for the Lead Powder. It is a fairly fine powder. The only information we have would be on the MSDS or Safety Data sheet. You can send an email to customer service at golfworks@golfworks.com and they can email you a copy of the MSDS sheet.
Answered by: JimY
Date published: 2016-01-28
  • y_2017, m_2, d_25, h_5CST
  • bvseo_bulk, prod_bvqa, vn_bulk_0.0
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_5
  • loc_en_US, sid_LP, prod, sort_[SortEntry(order=LAST_APPROVED_ANSWER_SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_golfworks