Self-Centering Graphite Shaft Tip Cleaner

Self-Centering Graphite Shaft Tip Cleaner

Self-Centering Shaft Tip Cleaner
In Stock

Self-Centering Graphite Shaft Tip Cleaner

A must have tool for any repair shop. To reuse a graphite shaft, the old epoxy in the tip must be bored out. Mount the chuck on the tip of the shaft. Clamp the shaft into the vise. The chuck acts as a guide for a 1/8" drill bit used to drill out old epoxy without damaging the shaft and attaches securely to a wide variety of shaft sizes. 1/8" drill bit included.

Self-Centering Graphite Shaft Tip Cleaner is rated 3.0 out of 5 by 1.
Rated 3 out of 5 by from Too small The drill is smaller than graphite tip weights. Tip weights won't fit without drilling a larger hole by hand
Date published: 2017-05-16
  • y_2017, m_11, d_17, h_23
  • bvseo_bulk, prod_bvrr, vn_bulk_2.0.3
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_1
  • loc_en_US, sid_GW1110, prod, sort_[SortEntry(order=RELEVANCE, direction=DESCENDING)]
  • clientName_golfworks

Do you need to clean out all of the epoxy in the tip or just make sure there is a passage for the air / epoxy to move through?

Asked by: GCD
No you do not need to clean out the whole tip end of the shaft. You just need an air passage through the shaft.
Answered by: JimY
Date published: 2017-06-05

Where can I find the instructions how to use this?

Asked by: Brett
To use the Self-Centering Tool you install the tool over the tip end of a graphite shaft and tighten it. Use the 1/8" drill bit to drill up through the center of the Self-Centering Tool to remove epoxy from the inside tip of the graphite shaft. When finished I always hold the shaft up to a light to make sure I can see through the inside of the shaft from the tip end to the butt end.
Answered by: JimY
Date published: 2016-04-29
  • y_2017, m_11, d_17, h_23CST
  • bvseo_bulk, prod_bvqa, vn_bulk_2.0.3
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_2
  • loc_en_US, sid_GW1110, prod, sort_[SortEntry(order=LAST_APPROVED_ANSWER_SUBMISSION_TIME, direction=DESCENDING)]
  • clientName_golfworks