The GolfWorks Maximum Strength High Impact Epoxy
Stronger Adhesion At Half The Cost!
The new GolfWorks Maximum Strength High Impact and Tour Set Plus Epoxies have been formulated to match the peel and shear strength of premium 3MŪ epoxies only with more elastic qualities specifically needed for proper golf club head/shaft adhesion, at about half the cost. The Maximum Strength High Impact epoxy is formulated for the high volume clubmaker to gel in approximately 1 hour while the Maximum Strength Tour Set Plus epoxy with a gel time of 20-30 minutes is intended for smaller jobs and/or when you simply need to expedite the curing process. Both Maximum Strength epoxies feature a shear strength of 4500 psi and require a 2:1 mix ratio.
The GolfWorks Maximum Strength High Impact Burst Pouch contains more than enough epoxy (20ml) for a complete set of golf clubs and does not require an expensive 2:1 epoxy mixing gun. Simply roll up one side of the pouch to create internal pressure and the contents will burst together. Mix the epoxy inside the bag by hand or against the edge of a workbench, cut a corner with scissors and dispense. Applicator stick and mixing board are included.
NOTE: The GolfWorks Epoxy Cartridge Gun (VB1005) equipped with a 2:1 plunger is required for proper dispensing of Maximum Strength High Impact and Maximum Strength Tour Set epoxies. Maximum Strength Quick Set is a 1:1 mix and does not require an epoxy mixing gun.