The GolfWorks Lie Angle Board

The GolfWorks Lie Angle Board


Heavy Duty Lie Angle Fit
$12.99
In Stock

The GolfWorks Lie Angle Board

Dynamic lie fitting checks the angle of the clubhead as it impacts the ball. This special hard rubber surface will leave a temporary mark on the sole of an iron to show if your club is too upright or flat. Board measures 8 inches by 16 inches with a 3/16-inch thickness.
The GolfWorks Lie Angle Board is rated 3.0 out of 5 by 1.
Rated 3 out of 5 by from Address Position Swing Left Of Logo ALWAYS SWING THE CLUB ON A LEVEL SURFACE FOR LIE ADJUSTMENTS!!. I found that the lie board can be greatly improved with a small door mat. Just fit the corners of the board under the mat with a utility knife with the lip of the carpet over the right edge to protect the club face from STRIKING THE RIGHT SIDE OF THE BOARD. Overall, the board is very strong and not forgiving, but lots of room improvement as I outlined for you.
Date published: 2010-09-08
  • 2016-07-25T07:49CST
  • bvseo_cps, prod_bvrr, vn_cps_3.3.0
  • cp_1, bvpage1
  • co_hasreviews, tv_0, tr_1
  • loc_en_US, sid_S1632, PRD, sort_relevancy
  • clientName_golfworks

What does the mat weigh? Thank you

Asked by: Benny
The S1632 Lie Angle Board weights 1 pound.
Answered by: JimY
Date published: 2016-07-13

I bought this board quite a while back and I'm just getting around to where I am going go use it. I am sure this is a dumb question but should it have the graphics and text facing up or shiny side up?

Asked by: Trevor
We use it with the graphics facing up.
Answered by: JimY
Date published: 2016-01-20
  • 2016-07-25T07:45CST
  • bvseo_cps, prod_bvqa, vn_cps_3.3.0
  • cp_1, bvpage1
  • co_hasquestionsanswers, tq_2
  • loc_en_US, sid_S1632, PRD, sort_recentAnswersFirst
  • clientName_golfworks