Measures up to 48 inches in 1/4-inch increments. Designed to be used flat on a workbench to reduce awkwardness and increase accuracy. Panel flips up to align with clubhead sole so accurate finished length is measured.
This product can expose you to chemicals including black (airborne, unbound particles of respirable size), which is know to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.
Important Note: Please provide Current contact information. Customer service may require further information before proceeding with your order.
PUREing - $25.00
SST PURE identifies asymmetries that exist in every golf shaft and locates each shaft's most stable orientation. This results in more consistent performance and uniform feel from club to club.
Tip Prepping - $2.95
Shafts are tip trimmed (if required) to manufacturer’s recommendations. For steel shafts, we abrade the tips. For graphite shafts, we remove the polyurethane coating. When you receive your shaft, all you need to do is mix epoxy, install and align. After the epoxy is cured, cut to your final playing length from the butt end and install the grip.
Tip & Butt Trimming - $4.95
Shafts are tip trimmed (if required) to manufacturer’s recommendations. For steel shafts, we abrade the tips. For graphite shafts, we remove the polyurethane coating. After tip trimming and prepping, the shafts are butt trimmed to the desired final playing length*.